2016 hellcat CNC ported snout 105MM

[uncrnps]

$1100. Buyer pays the fees

105MM hellcat CNC ported snout by Kong Performance comes with metco hub

you get as you see in the picture. Just FYI. Metco hub works with Ripatuned pulley

 

[Mean Cat]

Looks good , GLWS !

 

[16GoManGoHC2]

If it had a 2.85 Litens on it I’d snatch it up, guess I’m going to have to send mine in.
good luck with sale!!

 

[Primetime Hellcat 17]

If it had a 2.85 Litens on it I’d snatch it up, guess I’m going to have to send mine in.
good luck with sale!!

Get the snout and you can by my litens 2.72 pulley?

 

[16GoManGoHC2]

I just purchased a complete blower that I’m going to be sending in for a full port job including the snout. I’ll probably then be making more boost then pump gas can handle with the 2.85 on a ported blower as it’s making 16-16.5 psi now but THANKS for the suggestion.

 

[uncrnps]

If it had a 2.85 Litens on it I’d snatch it up, guess I’m going to have to send mine in.
good luck with sale!!

i can remove metco hub and might be able to reduce price based on that. You can keep your snout and buy this. You might be able to recover some cost by selling your snout

 

[16GoManGoHC2]

Message me or post a price, I can get mine done with my pulley on it for $1050. Cost is reduced if they don’t have to disassemble and rebuild the snout.
Thanks!!

 

[uncrnps]

Snout never made any noise. May be I don’t run those anti slip pulley. I can reduce $200 from the price and remove metco pulley. $900

I’ve a demon Map sensor in the picture. So might not be compatible with your car so I might remove that too

 

[RGPIII]

Get the snout and you can by my litens 2.72 pulley?

Selling a 2.72????

 

[Primetime Hellcat 17]

Selling a 2.72????

Yes it’s for sale.
Only issue is that I will not have it off my car for another 2 weeks or so. It’s in the shop right waiting on the Magnuson SC.

 

[Primetime Hellcat 17]

Selling a 2.72????

Gotta a few things for sale in the FS forum.

 

[uncrnps]

SOLD